Neo6M GPS Module Ublox

U-Blox Neo-6M based GPS module with EEPROM included, includes antenna. It is compatible with various flight controllers that need GPS positioning.

The NEO 6M GPS module can work with a supply voltage in the range of 3V to 5V, while the signals that enter and leave the module are 3.3V, so a logic level converter is required if an Arduino board or a 5V microcontroller will communicate with GPS module. If you only want to receive the NMEA data, it is enough to connect the TX pin with the RX of the Arduino and receive the data sent by the module, in this case, you do not need to convert voltages because the Arduino recognizes the 3.3V as a high level.

Main features:

• DC power voltage: 3.5V to 5V
• Serial communication
• Active ceramic antenna included
• Signal Indicator LED
• Default baud: 9600
• EEPROM to save parameter settings
• Coordinate system: WGS-84
• Capture Sensitivity -148dBm
• Tracking Sensitivity: -161 dBm
• Maximum measurable height: 18000
• Maximum speed 515 m/s
• Accuracy: 1 micro second
• Receiver frequency: L1 (1575.42 MHz)
• C/A code 1.023 MHz
• Start time first time: 38s on average
• Start time : 35s on average
• Working temperature range: -40 °C to 85 °C
• Antenna dimensions: 23 mm x 23 mm
• Module dimensions: 24 mm x 30 mm