Motor Driver Driver Module (Bridge H Turn Inverter) TB6612

The TB6612FNG bridge module can control up to two DC motors with a constant current of 1.2A. It does not present heating, despite this, a lot of caution must be taken regarding its connections, since if it were to be incorrectly polarized, the integrity of the chip would be compromised.

For the TB 6612 FNG module to work correctly, you see the need to implement two power supplies, one to generate the operating logic voltage connected to the VCC pin, and another to supply voltage to the motors on the VM pin, because otherwise the motors and the logic circuit will share The power supply is quite feasible that the module can be affected.

Specifications:

• TB6612 FNG bridge module
• Operating Voltage (VCC): 2.7V to 5V
• Motor Supply Voltage (VM): Maximum 15V
• Maximum Supported Current: 1.2A
• Peak current: 3.2a
• Maximum frequency: 100kHz
• Built-in thermal shutdown circuit and low voltage detection circuit.
• CW / CCW / Short Brake Control Modes / Engine Stop
• Control on standby to save energy
• Capacitor filtering on both power lines
• Operating temperature: -20 °C ~ 85 °C